以LBT-6094为本体的LBT-2586J扩展战术携行具

作者：来源: 2012-03-23 00:04:10 阅读：次

以LBT-6094为本体的LBT-2586J战术携行具

LBT-2586J是一个全新设计的战术携行具，巧妙的接口设计可以与6094防弹衣直接结合。

LBT-2586J主要由一个MOLLE系统和两端的电台袋组成，两个弹匣包（三联7.62弹匣包和四联5.56弹匣包）

中文简译：以LBT-6094为本体的LBT-2586J战术携行具

LBT-2586J是一个全新设计的战术携行具，巧妙的接口设计可以与6094防弹衣直接结合。
LBT-2586J主要由一个MOLLE系统和两端的电台袋组成，两个弹匣包（三联7.62弹匣包和四联5.56弹匣包）

英文原文：
This is a brand new London Bridge Trading Item and they are calling it the LBT-2586J (2586 is their chest rigs) and what is cool about it is it is designed to interface directly with their 6094 Slick Plate Carriers.
The story I got on these is that they came out of a request from DevGru to have a chest rig that interfaced with the slick plate carrier – they called it a “crap panel” (as in you can carry crap on it).
Basically, what you get is a MOLLE sleeve with a radio pouch at each end, two attachment points to the plate carrier, and two “kangaroo pouches.” One kangaroo pouch will hold 4x 5.56 magazines, while the other will hold 3x 7.62 magazines and they slide into and attach to the chest rig via velcro. It should also be noted that these kangaroo pouches are bigger than the standard one that goes into the LBT-6094A (see picture below).
In short, I think it is a really cool rig. It carries magazines and radios, and nothing more and the way it tightens down on the side is real slick. It is also made out lightweight cordura as well, 500d most likely, which is great.

However, I have three big complaints:

The backstrap system seems, at best, to be clumsy to me – it is difficult to attach and deattach. The thicker, 2 inch webbing, is designed so it is less likely to slip off the plate carrier I think but it seems to me like there needs to be some way to attach it directly to the plate carrier. When I ran a Mayflower rig attached I took two RRV attachment straps and tied them off to the rear MOLLE webbing via elastic cord and that seemed to work great

I am not a big fan of the plastic piece that attaches itself to the webbing on the plate carrier. It is supposedly durable, I was told it could withstand 100 lbs of pressure, however it comes off at an awkward angle. When I attached a Mayflower chest rig I used QASM buckles which seemed cleaner but also sucked up both webbing points, while this only uses one.

There seems to be an annoying amount of standoff between the mags and the vest however that is probably due to the design of the slick, namely the elastic cummerbund and flap, than anything else.

As always, I am not a faceshooter so take what I say with a grain of salt as I have not even worn this rig for more than 5 minutes much less used it in combat.